NEW TMB nanoScope DMX Tester

Description

The nanoScope is a DMX512/RDM tester built into an XLR connector. It is a small battery powered tester for DMX512 and RDM that lights up in different colours to let you know what it finds.

There are two modes, which you can select by a recessed slide switch which is also the power switch. In 'Pixel Mode', nanoScope displays the first 3 DMX channels as an RGB mix. This allows the tool to be used as a pixel mimic to provide confidence that the expected data is on the cable. 'Analysis Mode' displays coloured blips that represent different attributes of the DMX signal. The sequence comprises one long blip followed by a train of short blips. The long blips will be either green or red to indicate overall good or bad data respectively.

Color Code:

Orange: Break Length out of range, less than 88uS (an error)
Magenta: Mark After Break (MaB), less than 8uS (an error)
Yellow: Framing error (an error but does occur legitimately during RDM discovery)
Red: RDM data format wrong (an error)
Pink: Packet too long, contains more than 512 channels (an error)
Cyan: Less than 512 channels in data (informational)
Warm White: Non-Zero start codes (excluding RDM) detected (usually informational but can be an error)
Green: RDM detected in data (informational)
Mint: RDM draft detected in data (informational)
UV Blue: RDM responses detected (informational)
Ice Blue: DMX Test Packets detected (informational)

NewLighting.com is proud to be an authorized dealer for the top manufacturers of theatrical lighting and event equipment. We carry factory sealed items that are shipped direct to your doorstep and include all applicable manufacturer warranties.